Resetting the Power Sunshade Motor-Control Unit: Procedure

NOTE:  Do the power sunshade clear, and then the position learning or the sliding surface learning when any of the following have occurred:

• The power sunshade stops during AUTO/MANUAL operation.
• The power sunshade does not work during AUTO operation.
• The power sunshade was moved manually while the battery was dead or disconnected.
• The panoramic glass roof motor was removed or replaced with a new one.
• Any of components related to the power sunshade were replaced or removed and installed.

1. Power Sunshade Control Unit - Clear 

   NOTE:  Refer to procedure of the panoramic glass roof control unit.

2. Power Sunshade Control Unit- Position Learning 

   NOTE:  Refer to procedure of the panoramic glass roof control unit.

3. Power Sunshade Control Unit- Sliding Surface Learning

   To perform the sliding surface learning the power sunshade control unit, do these steps: 1. Do the sliding surface learning by operating the AUTO function for both open and close of the power sunshade.