DTC U1280 (Front Seat Heater Control Unit)
DTC U1280 : Seat heater control unit communication bus line error (BUS-OFF)
NOTE:
- If you are troubleshooting multiple DTCs, be sure to follow the instructions in B-CAN System Diagnosis Test Mode A .
- The front seat heater control unit does not turn on the front seat heater until the seat core temperature is 185°F (85°C) or less. Make sure the seat core temperature is below 185°F (85°C) before troubleshooting.
| DTC Description | DTC |
|---|---|
| U1280 Seat heater control unit communication bus line error (BUS-OFF) |
DTC (Front Seat Heater Control Unit)
- Problem verification
-1. Clear the DTCs with the HDS.
-2. Turn the vehicle to the OFF (LOCK) mode and then the ON mode.
-3. Wait for at least 6 seconds.
-4. Check for DTCs with the HDS.
DTC Description DTC U1280 Seat heater control unit communication bus line error (BUS-OFF) Is DTC U1280 indicated?
YES
Go to body control module DTC U1280 troubleshooting .
NO
Intermittent failure, the system is OK at this time. Check for loose or poor connections.