DTC U1064 (Front Seat Heater Control Unit)

DTC U1064  : Seat heater control unit lost communication with climate control unit

NOTE: 

• If you are troubleshooting multiple DTCs, be sure to follow the instructions in B-CAN System Diagnosis Test Mode A .
• Refer to the DTC code shown on the display, and then inspect the connectors and terminals based on the instructions in the table below.
• The DTC may be stored due to the grounding failure or the power source failure at the transmitting control unit (the grounding inspection and the power source inspection on each control unit are required prior to this checking process).
• The front seat heater control unit does not turn on the front seat heater until the seat core temperature is 185°F (85°C) or less. Make sure the seat core temperature is below 185°F (85°C) before troubleshooting.

DTC (Front Seat Heater Control Unit)

1. Problem verification

   -1. Clear the DTC with the HDS.

   -2. Turn the vehicle to the OFF (LOCK) mode and then the ON mode.

   -3. Wait for at least 6 seconds.

   -4. Check for DTCs with the HDS.

   DTC Description	DTC
   U1064 Seat heater control unit lost communication with climate control unit

   Are any DTCs indicated?

   YES 

   Go to step 2.

   NO 

   Intermittent failure, the system is OK at this time. Check for poor connections or loose terminals.

2. Open wire check (B-CAN_H line, B-CAN_L line)

   -1. Turn the vehicle to the OFF (LOCK) mode.

   -2. Disconnect the receiving control unit connector.

   Front seat heater control unit 24P connector

   -3. Disconnect the transmitting control unit connector(s).

   Refer to the DTC shown on the display, then disconnect the connector(s) based on the instructions (see table).

   DTC	Connector
   U1064	Climate control unit connector A (32P)

   -4. Check for continuity between the receiving control unit and the transmitting control unit on the B-CAN_H circuit and the B-CAN_L circuit.

   Test condition

   Vehicle OFF (LOCK) mode Front seat heater control unit 24P connector: disconnectedTransmitting control unit connector(s) for indicated DTCs: disconnected

   DTC	Circuit name	Receiving control unit		Transmitting control unit
   		Connector	Terminal	Connector	Terminal
   U1064	B-CAN_H	Front seat heater control unit 24P connector	No. 10	Climate control unit connector A (32P)	No. 25
   	B-CAN_L		No. 9		No. 8

   Is there continuity?

   YES 

   The B-CAN_H wire and the B-CAN_L wire are OK.Refer to the DTC shown on the display, then replace the control unit based on the instructions (see chart below).

   DTC	Operation for transmitting control unit
   U1064	Climate control unit

   NO 

   Repair an open in the B-CAN_H wire and/or the B-CAN_L wire.