Immobilizer System Registration: Procedure

NOTE: 

• The HDS is required for registration of the immobilizer keys.
• Programming the immobilizer also programs the keyless transmitter.
• Check for aftermarket electrical equipment that can cause problems with transponder operation.
• The immobilizer-keyless control unit can store up to six immobilizer keys.

When Replacing the Immobilizer-Keyless Control Unit 

1. Have all registered keys and the PCM code.

2. Connect the HDS to the data link connector (DLC)

3. Turn the vehicle to the ON mode.

4. Select "Immobilizer Setup Tool".

5. Select the appropriate items, and do the registration according to the instructions on the HDS screen.

NOTE:  Program all of the customer's keys.

6. After registration, verify systems work normally with all keys.

When Replacing the PCM, the Body Control Module, or the VSA Modulator-Control Unit 

1. Have the PCM code.

2. Connect the HDS to the data link connector (DLC)

3. Turn the vehicle to the ON mode.

4. Select "Immobilizer Setup Tool".

5. Select the appropriate items, and do the registration according to the instructions on the HDS screen.

6. After registration, verify systems work normally with all keys. If the PCM is replaced, do the procedure after replacing PCM .