Immobilizer Key Registration: Procedure

NOTE: 

• The HDS is required for registration of the immobilizer keys.
• Programming the immobilizer also programs the keyless transmitter.
• Check for aftermarket electrical equipment that can cause problems with transponder operation.
• The immobilizer-keyless control unit can store up to six immobilizer keys.

Replace any of the Keys 

NOTE:  If any of the registered keys were lost, do the following procedure to delete the lost registered key.

1. Have at least one original key, all other keys to be registered and the first password.

2. Connect the HDS to the data link connector (DLC)

3. Turn the vehicle to the ON mode.

4. Select "Immobilizer Setup Tool".

5. Select the appropriate items, and do the registration according to the instructions on the HDS screen.

6. After registration, verify systems work normally with all keys.

All Keys are Lost 

1. Prepare all new keys and have the immobilizer PCM code.

2. Connect the HDS to the data link connector (DLC)

3. Select "Immobilizer Setup Tool", and turn the vehicle to ON mode according to the instructions on the HDS screen.

4. Select the appropriate items, and do the registration according to the instructions on the HDS screen.

5. After registration, verify systems work normally with all keys.