DTC 1302 (Audio Unit)

DTC 1302 : GPS Receiver Error 1

NOTE:

Check the vehicle 12 volt battery condition first .
This audio DTC sets when there is an internal GPS receiver problem (freeze error).
Before you troubleshoot, make sure to follow the General Troubleshooting Information .

Problem verification
-1. Clear the hard error codes .

-2. Turn the vehicle to the OFF (LOCK) mode.

-3. Wait for at least 6 seconds.

-4. Turn the vehicle to the ON mode, and wait at least 1 minute.

-5. Check for hard error codes .

Is DTC 1302 indicated?

YES

Replace the audio unit .

NO

Intermittent failure, the system is OK at this time.