The BSI indicator does not go off, or does not come on
- DTC check
-1. Turn the vehicle to the ON mode.
-2. Check for DTCs with the HDS.
DTC Description DTC DTC Description DTC DTC (BSI)
Are any DTCs indicated?
YES
Go to the indicated DTC troubleshooting .
NO
Go to step 2.
- Problem verification
-1. Turn the vehicle to the OFF (LOCK) mode, then the ON mode.
-2. Check the BSI indicator comes on, and then goes off.
Does the BSI indicator come on, then go off?
YES
Intermittent failure, the system is OK at this time. Refer to intermittent failures troubleshooting .
NO
Go to step 3.
- Vehicle settings check
-1. Check the BSI system is ON status, and make sure the BSI system customizing operation.
Is the BSI system ON?
YES
Go to step 4.
NO
Cancel the OFF status by operating the BSI customization.
- Gauge control module check
-1. Do the gauge control module self-diagnostic function .
Is the gauge control module OK?
YES
Replace the appropriate BSI radar unit .
NO