DTC B2A60-A3, U3006-17

DTC B2A60-A3  : Power Supply Voltage Too High (Multipurpose Camera Unit)

DTC U3006-17  : Power Supply Voltage Too High (Millimeter Wave Radar)

NOTE: 

• Before you troubleshoot, review the general troubleshooting information .
• Before starting a troubleshooting, check that a 12 volt battery of a capacity compatible with the vehicle is installed.
• These DTCs are recorded when a voltage of 17 volt or more is supplied to the millimeter wave radar or the multipurpose camera unit.
• The functions of the integrated driver support system that will be temporarily canceled when this DTC is recorded can be confirmed with the DTC troubleshooting index .

DTC (IDAS)

1. Problem verification

   -1. Turn the vehicle to the ON mode.

   -2. Clear the DTC with the HDS.

   -3. Turn the vehicle to the OFF (LOCK) mode.

   -4. Turn the vehicle to the ON mode, then wait for at least 6 seconds.

   -5. Check for DTCs with the HDS.

   DTC Description	DTC
   B2A60-A3 Power Supply Voltage Too High (Multipurpose Camera Unit)
   U3006-17 Power Supply Voltage Too High (Millimeter Wave Radar)

   Is DTC B2A60-A3 or U3006-17 indicated?

   YES 

   The failure is duplicated. Go to step 2.

   NO 

   Intermittent failure, the system is OK at this time. Refer to intermittent failures troubleshooting .

2. PGM-FI system DTC check

   -1. Turn the vehicle to the ON mode.

   -2. Check for DTCs with the HDS.

   DTC Description	Confirmed DTC	Pending DTC

   Are any DTCs indicated?

   YES 

   Go to the indicated DTC's troubleshooting in the PGM-FI system . After performing a DTC troubleshooting for the PGM-FI system, clear the DTC again.

   NO 

   Faulty a control unit, replace the control unit related to the DTC.