Removal and Installation

NOTE: 

• Where icon is shown, for further information continue to the information below.
• Strong impact (i.e., dropping the 12 volt battery, collision damage) may cause electrolyte leaks, internal short circuit and heat increase resulting in fire. Avoid impact to the 12 volt battery.
• Organic electrolyte is poisonous. If ingested, get medical attention immediately.
• 12 volt battery damage may cause flammable gas or electrolyte leaks and may result in fire. Do not damage the 12 volt battery and keep sparks, flame and cigarettes away.
• Do the installation operation after reconnecting the 12 volt battery terminal .

1 

Courtesy of HONDA, U.S.A., INC.

	Detailed information, notes, and precautions
	Torque: N.m (kgf.m, lbf.ft)
*1	For some model

1. 12 Volt Battery Terminals - Disconnect 

   NOTE:  Do the installation operation after reconnecting the 12 volt battery terminal.

2. 12 Volt Battery Setting Plate - Remove

   NOTE:  Do not deform the 12 volt battery setting plate by over-tightening the nuts.

3. 12 Volt Battery Cover - Remove
4. 12 Volt Battery - Remove
5. 12 Volt Battery Box - Remove
6. All Removed Parts - Install

   1. Install the parts in the reverse order of removal.