DTC P281D, P281E (A/T)

DTC P281D  : Clutch Pressure Control Solenoid Valve H Circuit Low DTC P281E  : Clutch Pressure Control Solenoid Valve H Circuit High

NOTE:  Before you troubleshoot, review the General Troubleshooting Information .

DTC (A/T)

1. Problem verification

   -1. Turn the vehicle to the ON mode.

   -2. Clear the DTC with the HDS.

   -3. Turn the vehicle to the OFF (LOCK) mode.

   -4. Turn the vehicle to the ON mode, and wait for at least 1 second.

   -5. Check for Pending or Confirmed DTCs with the HDS.

   DTC Description	Confirmed DTC	Pending DTC	Freeze Frame
   P281D Clutch Pressure Control Solenoid Valve H Circuit Low
   P281E Clutch Pressure Control Solenoid Valve H Circuit High

   Is DTC P281D or P281E indicated?

   YES 

   The failure is duplicated. Check for any authorized service information related to the DTCs or symptoms you are troubleshooting, or substitute a known-good TCM , then recheck. If this DTC goes away and the TCM was substituted, replace the original TCM .

   NO 

   Intermittent failure, the system is OK at this time. Check for poor connections and loose terminals between clutch pressure control solenoid valve H and the TCM. If the freeze data/on-board snapshot of this DTC is recorded, try to reproduce the failure under the same conditions with the freeze data/on-board snapshot.