DTC P087B, P087C, P087D (A/T)

DTC P087B  : Two-Way Clutch Actuator Valve Stroke Sensor B Out of Range DTC P087C  : Two-Way Clutch Actuator Valve Stroke Sensor B Circuit Low DTC P087D  : Two-Way Clutch Actuator Valve Stroke Sensor B Circuit High

NOTE:  Before you troubleshoot, review the General Troubleshooting Information .

DTC (A/T)

1. Problem verification

   -1. Turn the vehicle to the ON mode.

   -2. Clear the DTC with the HDS.

   -3. Test-drive under these conditions:

   DTC	Test Condition
   P087B	Start the engine. While pressing the brake pedal, wait for several seconds in each of D and R positions/modes.
   P087C P087D	Turn the vehicle to the OFF (LOCK) mode. Turn the vehicle to the ON mode, and wait for at least 2 seconds.

   -4. Check for Pending or Confirmed DTCs with the HDS.

   DTC Description	Confirmed DTC	Pending DTC	Freeze Frame
   P087B Two-Way Clutch Actuator Valve Stroke Sensor B Out of Range
   P087C Two-Way Clutch Actuator Valve Stroke Sensor B Circuit Low
   P087D Two-Way Clutch Actuator Valve Stroke Sensor B Circuit High

   Is DTC P087B, P087C, or P087D indicated?

   YES 

   The failure is duplicated. Check for any authorized service information related to the DTCs or symptoms you are troubleshooting, or substitute a known-good TCM , then recheck. If this DTC goes away and the TCM was substituted, replace the original TCM .

   NO 

   Intermittent failure, the system is OK at this time. Check for poor connections and loose terminals between the two-way clutch actuator valve stroke sensor and the TCM. If the freeze data/on-board snapshot of this DTC is recorded, try to reproduce the failure under the same conditions with the freeze data/on-board snapshot.