LEMON Manuals: Even more car manuals for everyone
Home >> Honda >> 2021 >> Accord Touring >> Repair and Diagnosis >> Transmission >> Automatic Trans >> Automatic Transaxle - DTC Diagnostics (P0876 - U1260) (Except Hybrid) >> DTC Troubleshooting >> DTC P0876, P0877, P0878 (A/T)

DTC P0876, P0877, P0878 (A/T)

DTC P0876  : Transmission Fluid Pressure Sensor D Out of Range DTC P0877  : Transmission Fluid Pressure Sensor D Circuit Low DTC P0878  : Transmission Fluid Pressure Sensor D Circuit High

NOTE:  Before you troubleshoot, review the General Troubleshooting Information .

DTC Description Confirmed DTC Pending DTC Freeze Frame
P0876 Transmission Fluid Pressure Sensor D Out of Range      
P0877 Transmission Fluid Pressure Sensor D Circuit Low      
P0878 Transmission Fluid Pressure Sensor D Circuit High      

DTC (A/T)

  1. Problem verification

    -1. Turn the vehicle to the ON mode.

    -2. Clear the DTC with the HDS.

    -3. Test-drive under these conditions:

    DTC Test Condition
    P0876
    • Start the engine.
    • While pressing the brake pedal, wait for several seconds in each of P position/mode and other than P position/mode.
    P0877
    P0878
    • Turn the vehicle to the OFF (LOCK) mode.
    • Turn the vehicle to the ON mode.

    -4. Check for Pending or Confirmed DTCs with the HDS.

    DTC Description Confirmed DTC Pending DTC Freeze Frame
    P0876 Transmission Fluid Pressure Sensor D Out of Range      
    P0877 Transmission Fluid Pressure Sensor D Circuit Low      
    P0878 Transmission Fluid Pressure Sensor D Circuit High      

    Is DTC P0876, P0877, or P0878 indicated?

    YES 

    The failure is duplicated. Check for any authorized service information related to the DTCs or symptoms you are troubleshooting, or substitute a known-good TCM , then recheck. If this DTC goes away and the TCM was substituted, replace the original TCM .

    NO 

    Intermittent failure, the system is OK at this time. Check for poor connections and loose terminals between transmission fluid pressure sensor D and the TCM. If the freeze data/on-board snapshot of this DTC is recorded, try to reproduce the failure under the same conditions with the freeze data/on-board snapshot.