P0806, P0807, P0808 (A/T)
| DTC P0806
: Two-Way Clutch Actuator Valve Stroke Sensor A Out of Range DTC P0807 : Two-Way Clutch Actuator Valve Stroke Sensor A Circuit Low DTC P0808 : Two-Way Clutch Actuator Valve Stroke Sensor A Circuit High |
NOTE: Before you troubleshoot, review the General Troubleshooting Information .
| DTC Description | Confirmed DTC | Pending DTC | Freeze Frame |
|---|---|---|---|
| P0806 Two-Way Clutch Actuator Valve Stroke Sensor A Out of Range | |||
| P0807 Two-Way Clutch Actuator Valve Stroke Sensor A Circuit Low | |||
| P0808 Two-Way Clutch Actuator Valve Stroke Sensor A Circuit High |
DTC (A/T)
- Problem verification
-1. Turn the vehicle to the ON mode.
-2. Clear the DTC with the HDS.
-3. Test-drive under these conditions:
DTC Test Condition P0806 - Start the engine.
- While pressing the brake pedal, wait for several seconds in each of D and R positions/modes.
P0807P0808 - Turn the vehicle to the OFF (LOCK) mode.
- Turn the vehicle to the ON mode, and wait for at least 2 seconds.
-4. Check for Pending or Confirmed DTCs with the HDS.
DTC Description Confirmed DTC Pending DTC Freeze Frame P0806 Two-Way Clutch Actuator Valve Stroke Sensor A Out of Range P0807 Two-Way Clutch Actuator Valve Stroke Sensor A Circuit Low P0808 Two-Way Clutch Actuator Valve Stroke Sensor A Circuit High Is DTC P0806, P0807, or P0808 indicated?
YES
The failure is duplicated. Check for any authorized service information related to the DTCs or symptoms you are troubleshooting, or substitute a known-good TCM , then recheck. If this DTC goes away and the TCM was substituted, replace the original TCM .
NO
Intermittent failure, the system is OK at this time. Check for poor connections and loose terminals between the two-way clutch actuator valve stroke sensor and the TCM. If the freeze data/on-board snapshot of this DTC is recorded, try to reproduce the failure under the same conditions with the freeze data/on-board snapshot.