P07AA, P07AB (A/T)

DTC P07AA  : Brake B2 Stuck OFF

DTC P07AB  : Brake B2 Stuck ON

NOTE:  Before you troubleshoot, review the General Troubleshooting Information .

DTC (A/T)

1. Problem verification

   -1. Turn the vehicle to the ON mode.

   -2. Clear the DTC with the HDS.

   -3. Test-drive under these conditions:

   DTC	Test Condition
   P07AA	Start the engine. While pressing the brake pedal, shift the transmission to D position/mode, and wait for at least 10 seconds.
   P07AB	Start the engine, and wait for at least 10 seconds in P position/mode. While pressing the brake pedal, shift the transmission to D position/mode, and wait for at least 10 seconds.

   -4. Check for Pending or Confirmed DTCs with the HDS.

   DTC Description	Confirmed DTC	Pending DTC	Freeze Frame
   P07AA Brake B2 Stuck OFF
   P07AB Brake B2 Stuck ON

   Is DTC P07AA or P07AB indicated?

   YES 

   The failure is duplicated. Replace the valve body assembly .

   NO 

   Intermittent failure, the system is OK at this time. If the freeze data/on-board snapshot of this DTC is recorded, try to reproduce the failure under the same conditions with the freeze data/on-board snapshot.