P07A6, P07A7 (A/T)

DTC P07A6  : Clutch C3 Stuck OFF

DTC P07A7  : Clutch C3 Stuck ON

NOTE:  Before you troubleshoot, review the General Troubleshooting Information .

DTC (A/T)

1. Problem verification

   -1. DTC P07A7: Raise the vehicle on a lift. Make sure it is securely supported, and allow all four wheels to rotate freely.

   -2. Turn the vehicle to the ON mode.

   -3. Clear the DTC with the HDS.

   -4. Test-drive under these conditions:

   DTC	Test Condition
   P07A6	Start the engine, and wait for at least 10 seconds in P position/mode. While pressing the brake pedal, shift the transmission to R position/mode, and wait for several seconds.
   P07A7	Start the engine, disable the VSA . Run the vehicle in 3rd gear with steady cruising, then slow down and stop the vehicle.

   -5. Check for Pending or Confirmed DTCs with the HDS.

   DTC Description	Confirmed DTC	Pending DTC	Freeze Frame
   P07A6 Clutch C3 Stuck OFF
   P07A7 Clutch C3 Stuck ON

   Is DTC P07A6 or P07A7 indicated?

   YES 

   The failure is duplicated. Replace the valve body assembly .

   NO 

   Intermittent failure, the system is OK at this time. If the freeze data/on-board snapshot of this DTC is recorded, try to reproduce the failure under the same conditions with the freeze data/on-board snapshot.