P07A4, P07A5 (A/T)

DTC P07A4  : Clutch C2 Stuck OFF

DTC P07A5  : Clutch C2 Stuck ON

NOTE:  Before you troubleshoot, review the General Troubleshooting Information .

DTC (A/T)

1. Problem verification

   -1. Raise the vehicle on a lift. Make sure it is securely supported, and allow all four wheels to rotate freely.

   -2. Turn the vehicle to the ON mode.

   -3. Clear the DTC with the HDS.

   -4. Test-drive under these conditions:

   DTC	Test Condition
   P07A4	Start the engine, disable the VSA . Run the vehicle from 1st gear to 2nd gear.
   P07A5	Start the engine, disable the VSA , and wait for at least 10 seconds in P position/mode. Run the vehicle in 2nd gear with steady cruising.

   -5. Check for Pending or Confirmed DTCs with the HDS.

   DTC Description	Confirmed DTC	Pending DTC	Freeze Frame
   P07A4 Clutch C2 Stuck OFF
   P07A5 Clutch C2 Stuck ON

   Is DTC P07A4 or P07A5 indicated?

   YES 

   The failure is duplicated. Replace the valve body assembly .

   NO 

   Intermittent failure, the system is OK at this time. If the freeze data/on-board snapshot of this DTC is recorded, try to reproduce the failure under the same conditions with the freeze data/on-board snapshot.