P0710, P0712, P0713 (A/T)
| DTC P0710
: ATF Temperature Sensor Out of Range DTC P0712 : ATF Temperature Sensor Circuit Low DTC P0713 : ATF Temperature Sensor Circuit High |
NOTE: Before you troubleshoot, review the General Troubleshooting Information .
| DTC Description | Confirmed DTC | Pending DTC | Freeze Frame |
|---|---|---|---|
| P0710 ATF Temperature Sensor Out of Range | |||
| P0712 ATF Temperature Sensor Circuit Low | |||
| P0713 ATF Temperature Sensor Circuit High |
DTC (A/T)
- Problem verification
-1. Turn the vehicle to the ON mode.
-2. Clear the DTC with the HDS.
-3. Turn the vehicle to the OFF (LOCK) mode.
-4. Turn the vehicle to the ON mode, and wait for at least 5 seconds in P position/mode.
-5. Check for Pending or Confirmed DTCs with the HDS.
DTC Description Confirmed DTC Pending DTC Freeze Frame P0710 ATF Temperature Sensor Out of Range P0712 ATF Temperature Sensor Circuit Low P0713 ATF Temperature Sensor Circuit High Is DTC P0710, P0712, or P0713 indicated?
YES
The failure is duplicated. Replace the valve body assembly. Also replace the TCM .
NO
Intermittent failure, the system is OK at this time. Check for poor connections and loose terminals between the ATF temperature sensor and the TCM. If the freeze data/on-board snapshot of this DTC is recorded, try to reproduce the failure under the same conditions with the freeze data/on-board snapshot.