DTC: C0061-F0, C0062-F0, C0063-F0 (Adaptive Damper Control Unit)
DTC C0061-F0 : Lateral G Sensor Failure DTC C0062-F0 : Longitudinal G Sensor Failure DTC C0063-F0 : Yaw Rate Sensor Failure
NOTE: Before you troubleshoot, review the general troubleshooting information .
| DTC Description | DTC |
|---|---|
| C0061-F0 Lateral G Sensor Failure | |
| C0062-F0 Longitudinal G Sensor Failure | |
| C0063-F0 Yaw Rate Sensor Failure |
DTC (Adaptive Damper System)
- Problem verification
-1. Turn the vehicle to the ON mode.
-2. Clear the DTC with the HDS.
-3. Turn the vehicle to the OFF (LOCK) mode.
Test-drive the vehicle under these conditions:
- Vehicle speed at 31 mph (50 km/h) or more for 10 seconds or more.
- Change lanes a few times.
NOTE: Drive the vehicle on the road, not on a lift.
-5. Check for DTCs with the HDS.
DTC Description DTC C0061-F0 Lateral G Sensor Failure C0062-F0 Longitudinal G Sensor Failure C0063-F0 Yaw Rate Sensor Failure Is DTC C0061-F0, C0062-F0, or C0063-F0 indicated?
YES
Check for loose terminals and poor connections in the adaptive damper control unit 24P connector. Check for any authorized service information related to the DTCs or symptoms you are troubleshooting. If they are OK, replace the SRS unit .
NO
Intermittent failure, the system is OK at this time. Refer to intermittent failures troubleshooting .