DTC U3000-51 (SRS Unit)

DTC U3000-51 : SRS Unit Programming Error

NOTE:

Before doing this troubleshooting procedure, find out if the vehicle was in a collision. If so, verify that all the required components were replaced with new components of the correct part number and were properly installed .
This DTC is indicated when the SRS unit update is not completed properly.
Never press the engine start/stop switch, while updating the SRS unit. If you press the engine start/stop switch, before you complete the SRS unit update procedure, the SRS unit can be damaged. If there is a problem with the update, keep the vehicle in ON mode.
Before doing this troubleshooting procedure, review SRS Precautions and Procedures and General Troubleshooting Information .

DTC Description	DTC
U3000-51 SRS unit programming error

DTC (SRS)

Problem verification (update)

-1. Apply the parking brake.

-2. Do the SRS unit update procedure .

-3. Clear the DTCs with the HDS.

-4. Turn the vehicle to the ON mode, then wait for 10 seconds.

-5. Check for DTCs with the HDS.

DTC Description	DTC
U3000-51 SRS unit programming error

Is DTC U3000-51 indicated?

YES

The failure is duplicated. Check for any authorized service information related to the DTCs or symptoms you are troubleshooting or replace the SRS unit .

Update is complete.