DTC B2600-97 (2021)
DTC B2600-97 : Dust or Dirt On The Sensor
NOTE:
- If you are troubleshooting multiple DTCs, be sure to follow the instructions in B-CAN System Diagnosis Test Mode A .
- This DTC may store due to dirt or contaminants around the parking sensor.
| DTC Description | DTC |
|---|---|
| B2600-97 Dust Or Dirt On The Sensor |
DTCs (Parking and Back-Up Sensor Control Unit)
- Problem verification
-1. Wipe off any dirt or contaminants from the parking and back-up sensor, then recheck. If the DTC is duplicated, replace the appropriate parking and back-up sensor.
-2. Clear the DTCs with the HDS.
-3. Turn the vehicle to the OFF (LOCK) mode and then the ON mode.
-4. Wait for at least 6 seconds.
-5. Check for DTCs with the HDS.
DTC Description DTC B2600-97 Dust Or Dirt On The Sensor Is DTC B2600-97 indicated?
YES
Completely wipe off any dirt or contaminants from the parking and back-up sensor, then recheck. If the DTC is duplicated, replace the appropriate parking and back-up sensor .
NO
Intermittent failure, the system is OK at this time. Check for loose or poor connections.