DTC P2583-64
DTC P2583-64 : Millimeter Wave Radar Aiming Error
NOTE: Before you troubleshoot, review the general troubleshooting information .
| DTC Description | DTC | Freeze Frame |
|---|---|---|
| P2583-64 Millimeter Wave Radar Aiming Error |
DTC (IDAS)
- Problem verification
-1. Turn the vehicle to the ON mode.
-2. Clear the DTC with the HDS.
-3. Turn the vehicle to the OFF (LOCK) mode.
-4. Test-drive the vehicle on a straight road at speeds 25 mph (40 km/h) or more for 5 minutes with the ACC activated.
NOTE: Drive the vehicle on the road, not on a lift.
-5. Check for DTCs with the HDS.
DTC Description DTC Freeze Frame P2583-64 Millimeter Wave Radar Aiming Error Is DTC P2583-64 indicated?
YES
The failure is duplicated. Go to step 2.
NO
Intermittent failure, the system is OK at this time. Refer to intermittent failures troubleshooting . If the freeze data/on-board snapshot of this DTC is recorded, try to reproduce the failure under the same conditions with the freeze data/on-board snapshot.
- Millimeter wave radar installation check
-1. Remove the front bumper .
-2. Check the installation of the millimeter wave radar and the bracket.
Is the installation OK?
YES
Go to step 3.
NO
Reinstall or replace the part that has a problem, then go to step 3.
- Millimeter wave radar aiming
-1. Install the front bumper .
-2. Aim the millimeter wave radar .
-3. Turn the vehicle to the ON mode.
-4. Clear the DTC with the HDS.
-5. Turn the vehicle to the OFF (LOCK) mode.
-6. Test-drive the vehicle on a straight road at speeds 25 mph (40 km/h) or more for 5 minutes with the ACC activated.
NOTE: Drive the vehicle on the road, not on a lift.
-7. Check for DTCs with the HDS.
DTC Description DTC Freeze Frame P2583-64 Millimeter Wave Radar Aiming Error Is DTC P2583-64 indicated?
YES
Check for loose or poor connections. If OK, replace the millimeter wave radar .
NO
Troubleshooting is complete. If any other DTCs are indicated, go to the indicated DTC's troubleshooting.