DTC P2583-54
WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2020 Acura RLX, 2019 Acura RLX, 2018 Acura RLX, 2017 Acura RLX, and 2016 Acura RLX. However, it is still accessible from the selected car via links, so may be relevant.
DTC P2583-54 : Millimeter Wave Radar Aiming Incomplete
NOTE:
- Before you troubleshoot, review the general troubleshooting information .
- If the millimeter wave radar is removed or replaced, you must aim it, otherwise DTC P2583-54 is stored even if the system is OK.
| DTC Description | DTC | Freeze Frame |
|---|---|---|
| P2583-54 Millimeter Wave Radar Aiming Incomplete |
DTC (IDAS)
- Millimeter wave radar check (aiming)
-1. Turn the vehicle to the ON mode.
-2. Clear the DTC with the HDS.
-3. Aim the millimeter wave radar .
-4. Turn the vehicle to the OFF (LOCK) mode, then the ON mode.
-5. Check for DTCs with the HDS.
DTC Description DTC Freeze Frame P2583-54 Millimeter Wave Radar Aiming Incomplete Is P2583-54 indicated?
YES
Check for loose or poor connections. If OK, replace the millimeter wave radar .
NO
Troubleshooting is complete. If any other DTCs are indicated, go to the indicated DTC's troubleshooting.