DTC P0564-F0

WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2020 Acura RLX, 2019 Acura RLX, 2018 Acura RLX, 2017 Acura RLX, and 2016 Acura RLX. However, it is still accessible from the selected car via links, so may be relevant.

DTC P0564-F0 : ACC Switch Signal Circuit Error

NOTE: Before you troubleshoot, review the general troubleshooting information .

DTC Description	DTC	Freeze Frame
P0564-F0 ACC Switch Signal Circuit Error

DTC (IDAS)

DTC check

-1. Turn the vehicle to the ON mode.

-2. Clear the DTC with the HDS.

-3. Turn the vehicle to the OFF (LOCK) mode.

-4. Turn the vehicle to the ON mode, then wait for at least 5 seconds.

-5. Check for DTCs with the HDS.

DTC Description	DTC	Freeze Frame
P0564-F0 ACC Switch Signal Circuit Error

Is DTC P0564-F0 indicated?

YES

If only DTC P0564-F0 is indicated, go to step 2.

YES

If DTC P0564-11 or P0564-15 are also indicated, go to DTC P0564-11 or P0564-15 .

Intermittent failure, the system is OK at this time. Refer to intermittent failures troubleshooting . If the freeze data/on-board snapshot of this DTC is recorded, try to reproduce the failure under the same conditions with the freeze data/on-board snapshot.

Multipurpose camera unit check (update)

-1. Update the multipurpose camera unit if it does not have the latest software .

-2. Turn the vehicle to the OFF (LOCK) mode.

-3. Turn the vehicle to the ON mode, then wait for at least 5 seconds.

-4. Check for DTCs with the HDS.

DTC Description	DTC	Freeze Frame
P0564-F0 ACC Switch Signal Circuit Error

Is DTC P0564-F0 indicated?

YES

Check for loose terminals in the multipurpose camera unit 20P connector. If the multipurpose camera unit was updated and the symptom/indication is still present, replace the multipurpose camera unit .

Troubleshooting is complete. If any other DTCs are indicated, go to the indicated DTC's troubleshooting.