DTC C0041-14
WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2020 Acura RLX, 2019 Acura RLX, 2018 Acura RLX, 2017 Acura RLX, and 2016 Acura RLX. However, it is still accessible from the selected car via links, so may be relevant.
DTC C0041-14 : Brake Switch Signal Circuit Error
NOTE:
- Before you troubleshoot, review the general troubleshooting information .
- The specific conditions under which this DTC is recorded are as follows:
-
- -
Brake switch signal is ON, but brake fluid pressure does not rise when vehicle running.
- -
Brake switch signal is OFF, but brake fluid pressure rises when vehicle running.
- -
- This vehicle obtains the brake operation information used for the control of the integrated driver support system from the PCM via the F-CAN.
- If the DTC is recorded again after problem verification, perform a troubleshooting for the PGM-FI system .
- The functions of the integrated driver support system that will be temporarily canceled when this DTC is recorded can be confirmed with the DTC troubleshooting index .
| DTC Description | DTC |
|---|---|
| C0041-14 Brake Switch Signal Circuit Error |
DTC (IDAS)
- Problem verification
-1. Turn the vehicle to the ON mode.
-2. Clear the DTC with the HDS.
-3. Turn the vehicle to the OFF (LOCK) mode.
-4. Test-drive the vehicle at speeds 6 mph (10 km/h) for at least 30 seconds.
-5. Press the brake pedal for at least 2 seconds.
-6. Check for DTCs with the HDS.
DTC Description DTC C0041-14 Brake Switch Signal Circuit Error Is DTC C0041-14 indicated?
YES
Go to the indicated DTC's troubleshooting in PGM-FI system .
NO
Intermittent failure, the system is OK at this time. Refer to intermittent failures troubleshooting .