DTC B2A60-97

DTC B2A60-97  : Dust or Dirt On The Camera

NOTE: Before you troubleshoot, review the general troubleshooting information .

DTC (IDAS)

1. Multipurpose camera unit visual check

   -1. Check for dust or dirt at the multipurpose camera unit, and crack, dust, or interference at the windshield.

   Is the multipurpose camera unit and the windshield OK?

   YES 

   Go to step 2.

   NO 

   Clean the multipurpose camera surface, or both sides of the windshield surface. If necessary, replace or repair the windshield.

2. Problem verification

   -1. Turn the vehicle to the ON mode.

   -2. Clear the DTC with the HDS.

   -3. Turn the vehicle to the OFF (LOCK) mode.

   -4. Test-drive the vehicle at 3 mph (5 km/h) or more.

   -5. Check for DTCs with the HDS.

   DTC Description	DTC	Freeze Frame
   B2A60-97 Dust or Dirt On The Camera

   Is DTC B2A60-97 indicated?

   YES 

   The failure is duplicated. Go to step 3.

   NO 

   Intermittent failure, the system is OK at this time. Refer to intermittent failures troubleshooting . If the freeze data/on-board snapshot of this DTC is recorded, try to reproduce the failure under the same conditions with the freeze data/on-board snapshot.

3. Multipurpose camera unit check (update)

   -1. Update the multipurpose camera unit if it does not have the latest software .

   -2. Turn the vehicle to the OFF (LOCK) mode.

   -3. Test-drive the vehicle at 3 mph (5 km/h) or more.

   -4. Check for DTCs with the HDS.

   DTC Description	DTC	Freeze Frame
   B2A60-97 Dust or Dirt On The Camera

   Is DTC B2A60-97 indicated?

   YES 

   Check for loose terminals in the multipurpose camera unit 20P connector. If the multipurpose camera unit was updated and the symptom/indication is still present, replace the multipurpose camera unit .

   NO 

   Troubleshooting is complete. If any other DTCs are indicated, go to the indicated DTC's troubleshooting.