DTC B2A60-54
WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2020 Acura RLX, 2019 Acura RLX, 2018 Acura RLX, 2017 Acura RLX, and 2016 Acura RLX. However, it is still accessible from the selected car via links, so may be relevant.
DTC B2A60-54 : Static Camera Aiming Incomplete
NOTE:
- Before you troubleshoot, review the general troubleshooting information .
- If the multipurpose camera unit or the windshield is removed or replaced, you must aim it, otherwise DTC B2A60-54 is stored even if the system is OK.
| DTC Description | DTC | Freeze Frame |
|---|---|---|
| B2A60-54 Static Camera Aiming Incomplete |
DTC (IDAS)
- Problem verification
-1. Turn the vehicle to the ON mode.
-2. Clear the DTC with the HDS.
-3. Turn the vehicle to the OFF (LOCK) mode, then the ON mode.
-4. Check for DTCs with the HDS.
DTC Description DTC Freeze Frame B2A60-54 Static Camera Aiming Incomplete Is B2A60-54 indicated?
YES
The failure is duplicated. Do the static camera aiming .
NO
Intermittent failure, the system is OK at this time. Refer to intermittent failures troubleshooting . If the freeze data/on-board snapshot of this DTC is recorded, try to reproduce the failure under the same conditions with the freeze data/on-board snapshot.