DTC B2970 (B and MODE)

DTC B2970 or DTC indicator B and MODE  : A Short in the Mode Control Motor A Circuit (Front)

DTC (AC)

1. Problem verification

   - 1. Clear the DTC with the HDS.

   - 2. Turn the vehicle to the OFF (LOCK) mode then the ON mode.

   - 3. Do the Self-Diagnostic Function with the HDS or the climate control unit.

   - 4. Wait for at least 8 seconds.

   - 5. Check for DTCs.

   DTC Description	DTC
   B2970 A short in the mode control motor A circuit (front)

   Is DTC B2970 or B and MODE indicated?

   YES 

   Go to step 2.

   NO 

   Intermittent failure. Check for loose wires or poor connections on the mode control motor A circuit.

2. Determine possible failure area (SENSOR 5V line, others)

   - 1. Turn the vehicle to the OFF (LOCK) mode.

   - 2. Disconnect the following connector.

   Mode control motor A 7P connector

   - 3. Turn the vehicle to the ON mode.

   - 4. Measure the voltage between test points 1 and 2.

   Test condition	Vehicle ON mode
   	Mode control motor A 7P connector: disconnected
   Test point 1	Mode control motor A 7P connector No. 1
   Test point 2	Body ground

   Courtesy of HONDA, U.S.A., INC.

   Is there about 5 V?

   YES 

   The SENSOR 5V wire is OK. Go to step 3.

   NO 

   Go to step 6.

3. Mode control motor A check (MOD-P FR line)

   - 1. Measure the voltage between test points 1 and 2.

   Test condition	Vehicle ON mode
   	Mode control motor A 7P connector: disconnected
   Test point 1	Mode control motor A 7P connector No. 2
   Test point 2	Body ground

   Courtesy of HONDA, U.S.A., INC.

   Is there about 5 V?

   YES 

   The MOD-P FR wire is OK. Replace the mode control motor A .

   NO 

   Go to step 4.

4. Shorted wire check (MOD-P FR line)

   - 1. Turn the vehicle to the OFF (LOCK) mode.

   - 2. Disconnect the following connector.

   Climate control unit connector C (12P)

   - 3. Check for continuity between test points 1 and 2.

   Test condition	Vehicle OFF (LOCK) mode
   	Climate control unit connector C (12P): disconnected
   	Mode control motor A 7P connector: disconnected
   Test point 1	Climate control unit connector C (12P) No. 3 - Refer to: Climate Control Unit Connector For Inputs and Outputs (2019 2020 2021), or Climate Control Unit Connector For Inputs and Outputs (2016 2017 2018)
   Test point 2	Body ground

   Is there continuity?

   YES 

   Repair a short to body ground in the wire between the climate control unit and the mode control motor A.

   NO 

   The MOD-P FR wire is not shorted. Go to step 5.

5. Shorted wire check (MOD-P FR line to SENSOR(COM) line)

   - 1. Check for continuity between test points 1 and 2.

   Test condition	Vehicle OFF (LOCK) mode
   	Climate control unit connector C (12P): disconnected
   	Mode control motor A 7P connector: disconnected
   Test point 1	Mode control motor A 7P connector No. 2
   Test point 2	Mode control motor A 7P connector No. 3

   Courtesy of HONDA, U.S.A., INC.

   Is there continuity?

   YES 

   Repair a short in the wires between the climate control unit and the mode control motor A.

   NO 

   The MOD-P FR wire to SENSOR(COM) wire are OK. Replace the climate control unit .

6. Open wire check (SENSOR 5V line)

   - 1. Measure the voltage between test points 1 and 2.

   Test condition	Vehicle ON mode
   	Mode control motor A 7P connector: disconnected
   Test point 1	Climate control unit connector A (32P) No. 5 - Refer to: Climate Control Unit Connector For Inputs and Outputs (2019 2020 2021), or Climate Control Unit Connector For Inputs and Outputs (2016 2017 2018)
   Test point 2	Body ground

   Is there about 5 V?

   YES 

   Repair an open in the wire between the climate control unit and the mode control motor A.

   NO 

   The SENSOR 5V wire is not open. Go to step 7.

7. Shorted wire check (SENSOR 5V line)

   - 1. Turn the vehicle to the OFF (LOCK) mode.

   - 2. Disconnect the following connector.

   Climate control unit connector A (32P)

   - 3. Check for continuity between test points 1 and 2.

   Test condition	Vehicle OFF (LOCK) mode
   	Climate control unit connector A (32P): disconnected
   	Mode control motor A 7P connector: disconnected
   Test point 1	Climate control unit connector A (32P) No. 5 - Refer to: Climate Control Unit Connector For Inputs and Outputs (2019 2020 2021), or Climate Control Unit Connector For Inputs and Outputs (2016 2017 2018)
   Test point 2	Body ground

   Is there continuity?

   YES 

   Repair a short to body ground in the wire between the climate control unit and the mode control motor A.

   NO 

   The SENSOR 5V wire is OK. Replace the climate control unit .