DTC P0563 (19-21 9-Speed A/T)
DTC P0563 : Powertrain Control Module (PCM) Power Source Circuit Unexpected Voltage
NOTE: Before you troubleshoot, review the general troubleshooting information - Refer to: How to Troubleshoot the Fuel and Emissions Systems .
| DTC Description | Confirmed DTC | Pending DTC |
|---|---|---|
| P0563 Powertrain Control Module (PCM) Power Source Circuit Unexpected Voltage |
DTC (PGM-FI)
- Problem verification
- 1. Turn the vehicle to the ON mode.
- 2. Clear the DTC with the HDS.
- 3. Turn the vehicle to the OFF (LOCK) mode.
- 4. Wait 10 seconds.
- 5. Turn the vehicle to the ON mode.
- 6. Check for Pending or Confirmed DTCs with the HDS.
DTC Description Confirmed DTC Pending DTC P0563 Powertrain Control Module (PCM) Power Source Circuit Unexpected Voltage Is DTC P0563 indicated?
YES
The failure is duplicated. Go to step 2.
NO
Intermittent failure, the system is OK at this time. Check for poor connections or loose terminals at the relay circuit board (PGM-FI main relay 1 circuit) and the PCM. If the on-board snapshot of this DTC is recorded, try to reproduce the failure under the same conditions with the on-board snapshot - Refer to: How to Troubleshoot the Fuel and Emissions Systems .
- Relay circuit board check
- 1. Turn the vehicle to the OFF (LOCK) mode.
- 2. Remove and test the relay circuit board.
Is the relay OK?
YES
Go to step 3.
NO
- Shorted wire check (M RLY line)
- 1. Jump the SCS line with the HDS, and wait more than 1 minute.
- 2. Disconnect the following connector
PCM connector A (50P) - 3. Check for continuity between test points 1 and 2.
Test condition
Vehicle OFF (LOCK) mode PCM connector A (50P): disconnected Relay circuit board connector A (10P): disconnected Test point 1 PCM connector A (50P) No. 22 - Refer to:
PCM Connector for Inputs and Outputs (9-Speed A/T) (2019 2020 2021)Test point 2 Body ground Is there continuity?
YES
Repair a short in the M RLY wire between the PCM (A22) and the relay circuit board.
NO
The M RLY wire is OK. Go to step 4.
- Shorted wire check (IGP line to power)
- 1. Measure the voltage between test points 1 and 2.
Test condition
Vehicle OFF (LOCK) mode PCM connector A (50P): disconnected Test point 1 PCM connector A (50P) No. 4 - Refer to:
PCM Connector for Inputs and Outputs (9-Speed A/T) (2019 2020 2021)Test point 2 Body ground Is there battery voltage?
YES
Repair a short to power in the IGP wire between the PCM (A4) and the relay circuit board.
NO
The IGP wire is OK. Check for any authorized service information related to the DTCs or symptoms you are troubleshooting, or substitute a known-good PCM - Refer to: PCM Removal and Installation (9-Speed A/T) (2019 2020 2021) , then recheck. If DTC P0563 goes away and the PCM was substituted, replace the original PCM - Refer to: PCM Removal and Installation (9-Speed A/T) (2019 2020 2021) .