LEMON Manuals: Even more car manuals for everyone
Home >> Honda >> 2017 >> Pilot EX, FWD >> Repair and Diagnosis >> Brakes >> Traction Control >> Vehicle Stability Assist (VSA) System - DTC Diagnostics >> DTC Troubleshooting >> DTC: C0031-62, C0034-62, C0037-62, C003A-62

DTC: C0031-62, C0034-62, C0037-62, C003A-62

DTC C0031-62  : Left Front Wheel Speed Sensor Signal Compare Failure

DTC C0034-62  : Right Front Wheel Speed Sensor Signal Compare Failure

DTC C0037-62  : Left Rear Wheel Speed Sensor Signal Compare Failure

DTC C003A-62  : Right Rear Wheel Speed Sensor Signal Compare Failure

NOTE: Before You Troubleshoot, Review The General Troubleshooting Information .

DTC Description DTC Freeze Frame
C0031-62 Left Front Wheel Speed Sensor Signal Compare Failure    
C0034-62 Right Front Wheel Speed Sensor Signal Compare Failure    
C0037-62 Left Rear Wheel Speed Sensor Signal Compare Failure    
C003A-62 Right Rear Wheel Speed Sensor Signal Compare Failure    

DTCs (VSA)

  1. Problem verification

    -1. Turn the vehicle to the ON mode.

    - 2. Clear the DTC with the HDS.

    - 3. Turn the vehicle to the OFF (LOCK) mode, then start the engine.

    - 4. Test-drive the vehicle on the road in a straight line over 19 mph (30km/h) for 60 seconds or more.

    NOTE:  Drive the vehicle on the road, not on a lift.

    - 5. Check for DTCs with the HDS.

    DTC Description DTC Freeze Frame
    C0031-62 Left Front Wheel Speed Sensor Signal Compare Failure    
    C0034-62 Right Front Wheel Speed Sensor Signal Compare Failure    
    C0037-62 Left Rear Wheel Speed Sensor Signal Compare Failure    
    C003A-62 Right Rear Wheel Speed Sensor Signal Compare Failure    

    Is DTC C0031-62, C0034-62, C0037-62, or C003A-62 indicated?

    YES 

    The failure is duplicated. Go to step 2.

    NO 

    Intermittent failure, the system is OK at this time. Refer To Intermittent Failures Troubleshooting . If the freeze data/on-board snapshot of this DTC is recorded, try to reproduce the failure under the same conditions with the Freeze data/on-board snapshot.

  2. Wheel speed sensor installation check

    -1. Turn the vehicle to the OFF (LOCK) mode.

    - 2. Check that the appropriate wheel speed sensor is properly mounted.

    DTC Appropriate Wheel Speed Sensor
    C0031-62 Left-front
    C0034-62 Right-front
    C0037-62 Left-rear
    C003A-62 Right-rear

    Is the wheel speed sensor installation OK?

    YES 

    Go to step 3.

    NO 

    Reinstall The Wheel Speed Sensor , and recheck the mounting position, then go to step 1.

  3. Wheel speed sensor check (substitution)

    -1. Substitute a known-good wheel speed sensor.

    DTC Appropriate Wheel Speed Sensor
    C0031-62 Left-front
    C0034-62 Right-front
    C0037-62 Left-rear
    C003A-62 Right-rear

    - 2. Turn the vehicle to the ON mode.

    - 3. Clear the DTC with the HDS.

    - 4. Turn the vehicle to the OFF (LOCK) mode, then start the engine.

    - 5. Test-drive the vehicle on the road in a straight line over 19 mph (30km/h) for 60 seconds or more.

    NOTE:  Drive the vehicle on the road, not on a lift.

    - 6. Check for DTCs with the HDS.

    DTC Description DTC Freeze Frame
    C0031-62 Left Front Wheel Speed Sensor Signal Compare Failure    
    C0034-62 Right Front Wheel Speed Sensor Signal Compare Failure    
    C0037-62 Left Rear Wheel Speed Sensor Signal Compare Failure    
    C003A-62 Right Rear Wheel Speed Sensor Signal Compare Failure    

    Is DTC C0031-62, C0034-62, C0037-62, or C003A-62 indicated?

    YES 

    Check for loose terminals and poor connections in the VSA modulator-control unit 38P connector. If they are OK, replace the VSA modulator-control unit. refer to:

    Replace The VSA Modulator-Control Unit .

    NO 

    Replace The Original Wheel Speed Sensor .