LEMON Manuals: Even more car manuals for everyone
Home >> Honda >> 2017 >> Odyssey SE >> Repair and Diagnosis >> External Pages >> Different car >> Section 1 (Automatic Transmission - 5-Speed) >> Transmission Housing >> Reverse Idler Gear Disassembly/Inspection/Reassembly

Reverse Idler Gear Disassembly/Inspection/Reassembly

WARNING: This page is about a different car, the 2013 Honda Odyssey, 2012 Honda Odyssey, and 2011 Honda Odyssey. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the snap ring (A), then remove the thrust washer (B), the reverse idler gear (C), the needle bearings (D), and the thrust washer (E) from the reverse idler gear shaft/holder (F).
    Fig 1: Identifying Snap Ring, Thrust Washer, Reverse Idler Gear, Needle Bearings, Thrust Washer And Reverse Idler Gear Shaft/Holder
    G06967177Courtesy of AMERICAN HONDA MOTOR CO., INC.
  2. Inspect the reverse idler gear and the gear shaft for excessive wear and damage.
  3. Inspect the needle bearings for galling and rough movement.
  4. Install the thrust washer and the needle bearings over the gear shaft.
  5. Install the reverse idler gear in the direction shown.
  6. Install the thrust washer, then install the snap ring to secure the idler gear.
scientia non olet · About LEMON Manuals