Park Lever Shaft Bearing Replacement

WARNING: This page is about a different car, the 2013 Honda Odyssey, 2012 Honda Odyssey, and 2011 Honda Odyssey. However, it is still accessible from the selected car via links, so may be relevant.

Special Tools Required

Bearing Remover, 10 mm 07936-GE0A000
Slide Hammer 07936-371020A
Driver Handle, 15 x 135L 07749-0010000
Attachment, 22 x 24 mm 07746-001A800

Remove the park lever shaft bearing from the transmission housing using the 10 mm bearing remover head, the 10 mm bearing remover shaft, and the slide hammer.

Fig 1: Removing Park Lever Shaft Bearing From Transmission Housing Using Bearing Remover Head, Bearing Remover Shaft And Slide Hammer
Courtesy of AMERICAN HONDA MOTOR CO., INC.
Install a new bearing until it bottoms in the transmission housing using the driver handle and the 22 x 24 mm attachment.

Fig 2: Installing Bearing In Transmission Housing Using Driver Handle And Attachment
Courtesy of AMERICAN HONDA MOTOR CO., INC.