Transmission Fluid Pressure Switch A (2nd Clutch) Replacement

WARNING: This page is about a different car, the 2013 Honda Odyssey, 2012 Honda Odyssey, and 2011 Honda Odyssey. However, it is still accessible from the selected car via links, so may be relevant.

Remove the air cleaner (see AIR CLEANER ELEMENT INSPECTION/REPLACEMENT ).
Remove the intake air duct (see step 10 ).
Disconnect the transmission fluid pressure switch A (2nd clutch) connector, and remove transmission fluid pressure switch A (2nd clutch).

Fig 1: Transmission Fluid Pressure Switch A (2nd Clutch) Connector And Sealing Washer With Torque Specifications
Courtesy of AMERICAN HONDA MOTOR CO., INC.
Install a new transmission fluid pressure switch A (2nd clutch) with a new sealing washer (B), and tighten the switch.
Check the connector for corrosion, dirt, or oil, and clean or repair if necessary, then connect the connector securely.
Install the intake air duct (see step 72 ).
Install the air cleaner (see AIR CLEANER ELEMENT INSPECTION/REPLACEMENT ).