Park Lever Shaft Bearing Replacement

WARNING: This page is about a different car, the 2013 Honda Odyssey, 2012 Honda Odyssey, and 2011 Honda Odyssey. However, it is still accessible from the selected car via links, so may be relevant.

Special Tools Required

Bearing Remover Shaft Set, 12 mm 07936-166010A
Slide Hammer 07936-371020A
Driver Handle, 15 x 135L 07749-0010000
Attachment, 22 x 24 mm 07746-001A800

Remove the park lever shaft bearing from the torque converter housing using the 12 mm bearing remover shaft set and the slide hammer.

Fig 1: Removing Park Lever Shaft Bearing From Torque Converter Housing Using Bearing Remover Shaft Set And Slide Hammer
Courtesy of AMERICAN HONDA MOTOR CO., INC.
Install a new bearing until it bottoms out in the torque converter housing using the drive handle and the 22 x 24 mm attachment.

Fig 2: Installing Bearing In Torque Converter Housing Using Drive Handle And Attachment
Courtesy of AMERICAN HONDA MOTOR CO., INC.