Intermediary Shaft 4th Gear Installation

WARNING: This page is about a different car, the 2013 Honda Odyssey, 2012 Honda Odyssey, and 2011 Honda Odyssey. However, it is still accessible from the selected car via links, so may be relevant.

Special Tools Required

Driver Handle, 40 mm I.D. 07746-0030100

Wrap the shaft splines with tape, and install new O-rings in the 3rd clutch O-ring grooves, then remove the tape.
Install the 3rd clutch, 53 mm splined washer, the 30 x 52 x 3 mm thrust needle bearing, the needle bearing, 3rd gear, the 30 x 52 x 3 mm thrust needle bearing on the intermediary shaft.
Install the intermediary shaft 4th gear (A) using the 40 mm I.D. driver handle and a press.

Fig 1: Installing Intermediary Shaft 4th Gear Using I.D. Driver Handle And Press
Courtesy of AMERICAN HONDA MOTOR CO., INC.
Install the 19.8 mm cotters, the cotter retainer, and the snap ring.
Install the 26.5 mm washer on the top of the intermediary shaft.