DTC P0711: ATF Temperature Sensor (Range/Performance)
WARNING: This page is about a different car, the 2013 Honda Odyssey, 2012 Honda Odyssey, and 2011 Honda Odyssey. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
- Before you troubleshoot, record all freeze data and any on-board snapshot with the HDS, and review General Troubleshooting Information (see GENERAL TROUBLESHOOTING INFORMATION ).
- This code is caused by an electrical circuit problem and cannot be caused by a mechanical problem in the transmission.
- Turn the ignition switch to ON (II).
- Check the ATF Temperature with the HDS in the A/T Data List.
Does the ATF Temperature indicate -4°F (-20°C) or higher?
YES -Intermittent failure, the system is OK at this time.
NO -Go to step 3.
- Start the engine, and wait for at least 10 minutes. Test the stall speed RPM (see STALL SPEED TEST ) three times.
- Check the ATF Temperature with the HDS in the A/T Data List.
Does the ATF Temperature indicate -4°F (-20°C) or below?
YES -Replace the ATF temperature sensor (see ATF TEMPERATURE SENSOR REPLACEMENT ).
NO -Intermittent failure, the system is OK at this time.