Glove Box Lock Cylinder Replacement

NOTE: Take care not to scratch the glove box.

Remove the glove box (see GLOVE BOX REMOVAL/INSTALLATION ).
While lifting the glove box handle (A), pull one end of the retainer (B) out of its slot with a hook-shaped tool.
NOTE: Do not remove the retainer entirely. Leave one end of the retainer in its original position when removing the lock cylinder.

Fig 1: Pulling End Of Retainer Out Of Its Slot Using Hook-Shaped Tool
Courtesy of AMERICAN HONDA MOTOR CO., INC.
Remove the glove box lock cylinder (A).

Fig 2: Removing Glove Box Lock Cylinder
Courtesy of AMERICAN HONDA MOTOR CO., INC.
Reinstall the end of the retainer (A) in its slot, then reinstall the lock cylinder (B).
NOTE: Push the cylinder into place securely until the retainer snaps into place.

Fig 3: Installing Retainer And Lock Cylinder
Courtesy of AMERICAN HONDA MOTOR CO., INC.