Special Tools Required

KTC Trim Tool Set SOJATP2014*

*Available through the Honda Tool and Equipment Program; call 888-424-6857

NOTE:

Take care not to scratch the dashboard or the related parts.
Use the appropriate tool from the KTC trim tool set to avoid damage when removing components.

Remove these items:
- Center panel (see PASSENGER'S MIDDLE PANEL REMOVAL/INSTALLATION )
- Driver's vent panel (see DRIVER'S VENT PANEL REMOVAL/INSTALLATION )
Adjust the steering column to the full tilt down position and to the full telescopic out position.
Gently pull out the instrument visor (A) to detach the clips (B, C), then remove it.

Fig 1: Identifying Instrument Visor With Clips
Courtesy of AMERICAN HONDA MOTOR CO., INC.
Install the visor in the reverse order of removal, and note these items:
- If the clips are damaged or stress-whitened, replace them with new ones.
- Push the clips into place securely.