Tailgate Weatherstrip Replacement

NOTE: Take care not to scratch the body or the trim.

With power tailgate: Remove the left tailgate side trim (see TRIM REMOVAL/INSTALLATION - TAILGATE AREA ).
With power tailgate: Remove the pivot bracket mounting bolts, then lay the power tailgate rod (A) against the D-pillar trim (B).

Fig 1: Laying Power Tailgate Rod Against D-Pillar Trim
Courtesy of AMERICAN HONDA MOTOR CO., INC.
Remove the tailgate weatherstrip (A) by pulling it out.

Fig 2: Identifying Tailgate Weatherstrip And Alignment Mark
Courtesy of AMERICAN HONDA MOTOR CO., INC.
Locate the painted alignment mark (B) on the tailgate weatherstrip. Align the painted mark with the alignment notch in the center of the tailgate opening, and install the tailgate weatherstrip all the way around. Make sure there are no wrinkles in the weatherstrip.
With power tailgate: Fasten the pivot bracket (A) on the tailgate.

Fig 3: Pivot Bracket With Torque Specifications
Courtesy of AMERICAN HONDA MOTOR CO., INC.
With power tailgate: Reinstall the left tailgate side trim (see TRIM REMOVAL/INSTALLATION - TAILGATE AREA ).
Check for water leaks (see step 9 under HATCH GLASS ADJUSTMENT ).