Fan, Fan Motor, and Shroud Removal and Installation: Removal

Raise the vehicle on the lift.
Remove the splash shield (see SPLASH SHIELD REPLACEMENT ).
Remove the A/C compressor clutch connector (A) from the clamp, then remove the harness clamps (B).

Fig 1: Identifying A/C Compressor Clutch Connector And Harness Clamps
Courtesy of AMERICAN HONDA MOTOR CO., INC.
Lower the vehicle on the lift.
Remove the intake air tube (A) and the resonator chamber joint (B).

Fig 2: Identifying Intake Air Tube And Resonator Chamber Joint
Courtesy of AMERICAN HONDA MOTOR CO., INC.
Disconnect the fan motor connectors (A) and the harness clamps (B).

Fig 3: Identifying Fan Motor Connectors And Harness Clamps
Courtesy of AMERICAN HONDA MOTOR CO., INC.
Remove the coolant reservoir (A).

Fig 4: Identifying Coolant Reservoir, A/C Condenser Fan Shroud Assembly And Radiator Fan Shroud Assembly
Courtesy of AMERICAN HONDA MOTOR CO., INC.
Remove the A/C condenser fan shroud assembly (B), then remove the radiator fan shroud assembly (C) from the A/C condenser fan shroud side.
Disassemble the fan shrouds.

Fig 5: Disassembled View Of Fan Shrouds
Courtesy of AMERICAN HONDA MOTOR CO., INC.