3-Mode drive system does not change when the mode button is pressed
- Turn the ignition switch to ON (II).
- Check the indication of SPORT, NORMAL, and ECON mode indicators.
Is there indication?
YES -Go to step 4.
NO -Go to step 3.
- Check the indication of MID in gauge control module.
Does the MIL and/or EPS indicated?
YES -Go to the INDICATED DTC'S TROUBLESHOOTING .
NO -Go to the DTC U0100 troubleshooting (see DTC U0100: GAUGE CONTROL MODULE LOST COMMUNICATION WITH ECM/PCM ).
- Press each button of the 3-Mode switch, and check the indication in the MID.
Is the indication changed when the switch is pressed?
YES -Intermittent failure, the system is OK at this time.
NO -Go to step 5.
- Select GAUGES from the BODY ELECTRICAL menu, and enter the DATA LIST with the HDS.
- Check the ON/OFF information of the SPORT SWITCH, NORMAL SWITCH, and ECON SWITCH in the DATA LIST.
Does each switch indicate ON when it is pressed?
YES -Replace the gauge control module (see GAUGE CONTROL MODULE REPLACEMENT ).
NO -Go to step 7.
- Turn the ignition switch to LOCK (0).
- Do the 3-Mode switch test (see 3-MODE SWITCH TEST/REPLACEMENT
).
Is the 3-Mode switch OK?
YES -Go to step 9.
NO -Replace the 3-Mode switch (see 3-MODE SWITCH TEST/REPLACEMENT ).
- Disconnect the 3-Mode switch 7P connector.
- Measure the voltage between 3-Mode switch 7P connector terminal No. 2 and body ground.
Courtesy of AMERICAN HONDA MOTOR CO., INC.
Is there battery voltage?
YES -Go to step 11.
NO -Go to step 13.
- Disconnect the gauge control module 32P connector.
- Check for continuity between gauge control module 32P connector terminal No. 2 and 3-Mode switch 7P connector terminal No. 7.Fig 2: Checking Continuity Between Gauge Control Module 32P Connector Terminal No. 2 And 3-Mode Switch 7P Connector Terminal No. 7
Courtesy of AMERICAN HONDA MOTOR CO., INC.
Is there continuity?
YES -Replace the gauge control module (see GAUGE CONTROL MODULE REPLACEMENT ).
NO -Repair an open or high resistance in the wire.
- Disconnect the gauge control module 32P connector.
- Check for continuity between gauge control module 32P connector terminal No. 12 and 3-Mode switch 7P connector terminal No. 2.Fig 3: Checking Continuity Between Gauge Control Module 32P Connector Terminal No. 12 And 3-Mode Switch 7P Connector Terminal No. 2
Courtesy of AMERICAN HONDA MOTOR CO., INC.
Is there continuity?
YES -Go to step 15.
NO -Repair an open or high resistance in the wire.
- Check for continuity between the gauge control module 32P connector terminal No. 12 and body ground.Fig 4: Checking Continuity Between Gauge Control Module 32P Connector Terminal No. 12 And Body Ground
Courtesy of AMERICAN HONDA MOTOR CO., INC.
Is there continuity?
YES -Repair a short to ground in the wire.
NO -Replace the gauge control module (see GAUGE CONTROL MODULE REPLACEMENT ).