Entering the Self-Diagnostic Function (Manual method)
- Push and hold the SELECT/RESET knob.
- Turn the combination light switch (
) ON.
- Turn the ignition switch to ON (II).
- Within 2-5 sec, turn the combination light switch (
) OFF, then ON and OFF again.
- Within 5 sec, release the SELECT/RESET knob, and then push and release the knob three times in a row.
NOTE:
- While in the self-diagnostic mode, the dashlights brightness controller operates normally.
- While in the self-diagnostic mode, the SELECT/RESET knob is used to start the Beeper Drive Circuit Test and the Gauge Drive Circuit Check.
- If the vehicle speed exceeds 1.2 mph (2km) or the ignition switch is turned to LOCK (0), the self-diagnostic mode ends.
- The SEL/RESET button of the multi-information switch can do the same functions as the SELECT/RESET knob.
Courtesy of AMERICAN HONDA MOTOR CO., INC.