Outside Air Temperature Indicator Calibration: Calibration

The outside air temperature indicator's displayed temperature can be recalibrated ±5°F (±3°C) to meet the customer's expectations.

1. Turn the ignition switch to ON (II).
2. Push and hold the INFORMATION (NEXT or PREVIOUS) button for at least 3 seconds to enter the customizing mode.
3. While in the customizing mode, select the CHG SETTING, and enter the METER SETUP. Then select the ADJUST OUTSIDE TEMP. DISPLAY, and calibrate the value with the SEL/RESET button and the INFORMATION (NEXT or PREVIOUS) button.
   Fig 1: Display - Outside Air Temperature Indicator's

   Courtesy of AMERICAN HONDA MOTOR CO., INC.
4. When the desired correction value appears on the display, release the button, and the recalibrated outside air temperature will be displayed.
   NOTE: The recalibration temperature is not the value the sensor sees.

   Therefore the temperature can only be adjusted ±5 degrees from sensors.

   Example: 

   Incorrect value = 68°F (20°C) 

   Desired correction value = +2°F (+1C°C) 

   Correct value = 70°F (21°C) 

   Desired correction value = -2°F (-1°C) 

   Correct value = 66°F (19°C) 

   NOTE: To recalibrate the display to the true temperature, remove the outside air temperature sensor (A), but leave it connected. Submerge the sensor and a thermometer (B) in a container of ice water (C). Select the calibration mode as described above, then recalibrate the display to the true temperature.

   Fig 2: Submerging Sensor And Thermometer In Container Of ICE Water

   Courtesy of AMERICAN HONDA MOTOR CO., INC.
5. The snow mark is displayed when the temperature is 37°F (3°C) or less the first time you turn the ignition switch to ON (II).
   Fig 3: Identifying Snow Mark

   Courtesy of AMERICAN HONDA MOTOR CO., INC.