Rear Evaporator Temperature Sensor Replacement

SRS components are located in this area. Review the SRS component locations (see COMPONENT LOCATION INDEX ) and the precautions and procedures (see PRECAUTIONS AND PROCEDURES ) before doing repairs or service.

1. Remove the center console (see CENTER CONSOLE REMOVAL/INSTALLATION ).
2. Disconnect the 2P connector (A) from the rear evaporator temperature sensor (B), then remove the connector clip (C). Remove the self-tapping screw and the rear evaporator temperature sensor from the rear HVAC unit.
   Fig 1: Identifying 2P Connector, Rear Evaporator Temperature Sensor And Connector Clip

   Courtesy of AMERICAN HONDA MOTOR CO., INC.
3. Install the sensor in the reverse order of removal.