Rear Air Mix Control Motor Replacement

SRS components are located in this area. Review the SRS component locations (see COMPONENT LOCATION INDEX ) and the precautions and procedures (see PRECAUTIONS AND PROCEDURES ) before doing repairs or service.

1. Remove the center console (see CENTER CONSOLE REMOVAL/INSTALLATION ).
2. Disconnect the 7P connector (A) from the rear air mix control motor (B). Remove the self-tapping screws and the rear air mix control motor from the rear HVAC unit.
   Fig 1: Identifying 7P Connector And Rear Air Mix Control Motor

   Courtesy of AMERICAN HONDA MOTOR CO., INC.
3. Install the motor in the reverse order of removal. Make sure the pin on the motor is properly engaged with the linkage. After installation, make sure the motor runs smoothly.