Glove Box Removal/Installation

SRS components are located in this area. Review the SRS component locations (see COMPONENT LOCATION INDEX ) and the precautions and procedures (see PRECAUTIONS AND PROCEDURES ) before doing repairs or service.

1. Remove the passenger's dashboard undercover (see PASSENGER'S DASHBOARD UNDERCOVER REMOVAL/INSTALLATION  ).
2. Remove the bolts, then remove the glove box (A).
   Fig 1: Glove Box With Torque Specifications

   Courtesy of AMERICAN HONDA MOTOR CO., INC.
3. While holding the glove box (A), release the glove box stops (B) on each side from the dashboard by pushing them in, then remove the glove box.
   Fig 2: Removing Glove Box

   Courtesy of AMERICAN HONDA MOTOR CO., INC.
4. Install the glove box in the reverse order of removal.