Rear Individual Map Light Test/Replacement

Turn the map light switch OFF.
Carefully pry off the lens (A) with a small screwdriver.
Rear Individual Map Light: 5 W x 2

Fig 1: Identifying Lens, 3P Connector, Housing And Bulb (Rear Individual Map Light)
Courtesy of AMERICAN HONDA MOTOR CO., INC.
Remove the two mounting screws.
Disconnect the 3P connector (B) from the housing (C).
Check for continuity between the terminals.
- There should be continuity between terminals No. 1 and No. 3 with the left switch ON.
- There should be continuity between terminals No. 1 and No. 2 with the right switch ON.
- There should be continuity between terminals No. 2 and No. 3 with the left switch OFF.
If the continuity is not as specified, check the bulb(s) (D). If the bulbs are OK, replace the light.
Install the parts in the reverse order of removal.