Immobilizer indicator does not go off

WARNING: This page is about a different car, the 2012 Honda Pilot. However, it is still accessible from the selected car via links, so may be relevant.

Turn the ignition switch to LOCK (0).
Connect the HDS to the data link connector.
Turn the ignition switch to ON (II).
From the SYSTEM SELECTION MENU, enter IMMOBI, then select IMMOBILIZER SETUP, then select SYSTEM CHECK, Number of Keys, and STATUS LOG.
Do the SYSTEM CHECK with the HDS.
Is N-1 OK indicated?

YES -Do the indicator drive circuit check (see SELF-DIAGNOSTIC FUNCTION ). If the indicator does not go off; replace the gauge control module (see GAUGE CONTROL MODULE REPLACEMENT ).

NO -Substitute a known-good immobilizer-keyless control unit, then register it and recheck. If the symptom goes away, replace the original immobilizer-keyless control unit (see IMMOBILIZER-KEYLESS CONTROL UNIT REPLACEMENT ).