DTC U3000-51: SRS Unit Programming Error (SRS Unit) (2017)

NOTE: 

• Before doing this troubleshooting procedure, find out if the vehicle was in a collision. If so, verify that all the required components were replaced with new components of the correct part number and were properly installed. Refer to: SRS Component Replacement/Inspection After Deployment
• This DTC is indicated when the SRS unit update is not completed properly.
• Never press the power button while updating the SRS unit. If you press the power button before you complete the SRS unit update procedure, the SRS unit can be damaged. If there is a problem with the update, keep the vehicle in ON mode.
• Before doing this troubleshooting procedure, review SRS Precautions and Procedures and General Troubleshooting Information .

DTC (SRS)

1. Problem verification (update)

   -1. Do the SRS unit update procedure.

   - 2. Clear the DTCs with the HDS.

   - 3. Turn the vehicle to the ON mode, then wait for 10 seconds.

   - 4. Check for DTCs with the HDS.

   DTC Description	DTC
   U3000-51 SRS unit programming error

   Is DTC U3000-51 indicated?

   YES 

   The failure is duplicated. Check for any authorized service information related to the DTCs or symptoms you are troubleshooting or replace the SRS unit .

   NO 

   Update is complete.