DTC U3000-51: SRS Unit Programming Error (SRS Unit) (2014-15)

NOTE: 

• Before doing this troubleshooting procedure, find out if the vehicle was in a collision. If so, verify that all the required components were replaced with new components of the correct part number and were properly installed. Refer to: SRS Component Replacement/Inspection After Deployment
• This DTC is indicated when the SRS unit update is not completed properly.
• Never press the engine start/stop button, while updating the SRS unit. If you press the engine start/stop button, before you complete the SRS unit update procedure, the SRS unit can be damaged. If there is a problem with the update, keep the vehicle in ON mode.
• Before doing this troubleshooting procedure, review SRS Precautions and Procedures and General Troubleshooting Information .

DTC (SRS)

1. System check

   -1. Do the SRS unit update procedure.

   - 2. Clear the DTCs with the HDS.

   - 3. Turn the vehicle to the ON mode, then wait for 10 seconds.

   - 4. Check for DTCs with the HDS.

   DTC Description	DTC
   U3000-51 SRS unit programming error

   Is DTC U3000-51 indicated?

   YES 

   Replace the SRS unit .

   NO 

   Update is complete.