DTC B00A0-54: Front Passenger's Weight Sensor Not Calibrated (2017)

NOTE: 

• Before doing this troubleshooting procedure, find out if the vehicle was in a collision. If so, verify that all the required components were replaced with new components of the correct part number and were properly installed. Refer to: SRS Component Replacement/Inspection After Deployment
• Before doing this troubleshooting procedure, review SRS Precautions and Procedures and General Troubleshooting Information .

DTC (SRS)

1. Problem verification

   -1. Clear the DTCs with the HDS.

   - 2. Turn the vehicle to the ON mode, then wait for 10 seconds.

   - 3. Check for DTCs with the HDS.

   DTC Description	DTC
   B00A0-54 Front passenger's weight sensor not calibrated

   Is DTC B00A0-54 indicated?

   YES 

   The failure is duplicated. Do the front passenger's weight sensor initialization .

   NO 

   Intermittent failure, the system is OK at this time. Go to Troubleshooting Intermittent Failures . If another DTC is indicated, troubleshoot the DTC.